Specifications Specification Category Parameter / Value General Product Type Built-in Amplifier Photoelectric Sensor Sensing Method Through-beam (Emitter + Receiver separate units) Shape Rectangular type (Flat) Sensing Distance 300 mm (11.811 inches) Minimum Sensing Object 1.3 mm diameter (opaque) Standard Sensing Object Opaque: 1.3 mm dia. min. Directional Angle Emitter: 3 to 25° / Receiver: 3° min. Housing Material Case: PBT (Polybutylene terephthalate) / Lens: Denatured Polyarylate Degree of Protection IP67 (IEC 60529) Mounting Method M2 screw mounting (screws included) Connection Method Pre-wired (2 m PVC cable) Weight (packaged) Approx. 40 g Optical & Performance Light Source Red LED (650 nm) visible light Response Time 1 ms max. (operate or reset) Electrical Output Configuration PNP open collector Operation Mode Light-ON (output ON when beam is received) Supply Voltage 12 to 24 VDC ±10% (ripple p-p 10% max.) Max. Supply Voltage 26.4 VDC Current Consumption Emitter: 10 mA max. / Receiver: 20 mA max. Output Current 50 mA max. Residual Voltage (Load <10 mA) 1 V max. Residual Voltage (Load 10-50 mA) 2 V max. Protective Circuits Output short-circuit protection, Output reverse polarity protection, Power supply reverse polarity protection Indicators Operation Indicator Orange LED (lights when output is ON) Stability Indicator Green LED (lights when incident light is stable) Environmental Ambient Temperature (Operating) -25 to 55 °C (with no freezing or condensation) Ambient Temperature (Storage) -40 to 70 °C Ambient Humidity (Operating) 35% to 85% Ambient Illuminance Incandescent lamp: 5,000 lx max. / Sunlight: 10,000 lx max. Insulation Resistance 20 MΩ min. (at 500 VDC) Dielectric Strength 1000 VAC at 50/60 Hz for 1 min Vibration Resistance (Destruction) 10 to 2000 Hz, 1.5 mm or 300 m/s², 0.5 h each in X, Y, Z Shock Resistance (Destruction) 1000 m/s², 3 times each in X, Y, Z Physical Dimensions Width 12 mm Height 15.8 mm