Specifications General & Performance Parameter Value Sensing head size M8 Type Cylindrical, Shielded (Flush mountable) Sensing distance 2 mm ±10% Setting distance 0 to 1.6 mm Hysteresis (Differential distance) 10% max. of sensing distance Sensing object Ferrous metal (Sensitivity lowers with non-ferrous metals) Standard sensing object Iron, 8 x 8 x 1 mm Response frequency 1.5 kHz Power source DC 2-wire models Electrical Specifications Parameter Value Power supply voltage (rated) 12 to 24 VDC (ripple p-p 10% max.) Operating voltage range 10 to 30 VDC Control output (Switching capacity) 3 to 100 mA Leakage current 0.8 mA max. Residual voltage 3 V max. (at 100 mA load current) Operation mode NO (Normally Open) Protective circuits Output short-circuit protection, Surge suppressor Polarity With polarity Note: As a DC 2-wire sensor, the E2E-X2D1-M1G-Z connects in series with the load. When the sensor is OFF, a small leakage current (0.8 mA max.) flows through the load. Connector Pin Assignment Pin Assignment Function 1 +V Power supply positive (10-30 VDC) 4 0 V Power supply negative (GND) Applicable connector code: A Indicators Parameter Value Operation indicator Red LED (lights when output is ON) Environmental Specifications Parameter Value Ambient temperature (Operating) -25 to 70°C (with no icing or condensation) Ambient temperature (Storage) -40 to 85°C Ambient humidity (Operating) 35% to 95% RH (with no condensation) Temperature influence ±10% max. of sensing distance over -25 to +70°C range (based on 23°C) Voltage influence ±1% max. of sensing distance within rated voltage range ±15% Degree of protection IP67 (IEC standard)