Technical Specifications Parameter Specification Type General Purpose Digital Fiber Amplifier Light Source (Wavelength) Red LED (650 nm) Power Supply Voltage 12 to 24 VDC ±10%; ripple (p-p): 10% max. Current / Power Consumption Normal: 40 mA max. (960 mW max.); ECO1: 30 mA max.; ECO2: 25 mA max. Control Output NPN open-collector; 50 mA max. (26.4 VDC max.); Residual voltage: 2 V max. Protective Circuits Power supply reverse polarity protection, Output short-circuit protection, Output reverse polarity protection Response Time Super-high-speed: 80 µs (Operation/Reset); High-speed: 250 µs; Standard: 1 ms; High-resolution: 4 ms; TOUGH mode: 16 ms Sensitivity Setting Teaching method (One-point, Two-point, Position) or manual adjustment via digital keys Timer Function Selectable: OFF-delay, ON-delay, One-shot, or ON-delay + OFF-delay timer; Adjustable 1 ms to 5 s Auto Power Control (APC) Digital control of LED emission current to compensate for light degradation over time Active Threshold Control (ATC) Automatically adjusts the threshold to maintain stable detection External Input Non-voltage input (contact/solid state) for remote teaching, power tuning, etc. Mutual Interference Prevention Up to 10 units Digital Display Dual 4-digit display showing light intensity and threshold value Degree of Protection IEC IP50 (when protective cover is attached) Connection Method Pre-wired cable (standard length: 2 m) Ambient Temperature (Operating) 1-2 units: -25°C to 55°C; 3-10 units: -25°C to 50°C; 11-16 units: -25°C to 45°C Ambient Humidity (Operating) 35% to 85% (with no condensation) Ambient Illuminance Incandescent: 10,000 lx max.; Sunlight: 20,000 lx max. Vibration Resistance 10 to 55 Hz, 1.5 mm double amplitude, 2 hours in X, Y, Z directions Shock Resistance 500 m/s², 3 times in X, Y, Z directions Material (Case) Polybutylene terephthalate (PBT) Material (Hood) Polycarbonate Weight (Packed) Approx. 100 g