Specifications Parameter Specification Sensing Method Diffuse-reflective (mark detection) Sensing Distance 10 ±3 mm (White paper 10 x 10 mm) Spot Size (reference) 1 x 4 mm Light Source (wavelength) Red LED (635 nm) Green LED (525 nm) Blue LED (465 nm) Output Type Push-pull (30 VDC max., 100 mA max.) Operation Mode High when mark is detected Response Time 2-point teaching mode: Operate or reset: 50 µs max. 1-point teaching mode: Operate or reset: 150 µs max. Supply Voltage 10 to 30 VDC, ripple (p-p) 10% included Current / Power Consumption 40 mA max. / 960 mW max. (at 24 VDC) Sensitivity Setting Teaching method Timer Function Selectable from: Timer disabled, OFF-delay, ON-delay, One-shot, or ON-delay + OFF-delay timer (0.1 to 5000 ms) Protective Circuits Output short-circuit protection, Output reverse polarity protection, Power supply reverse polarity protection Degree of Protection IEC: IP67 (NEMA 4X indoors) Ambient Temperature (Operating) -10 to 55°C (with no freezing or condensation) Ambient Temperature (Storage) -25 to 70°C Ambient Humidity (Operating) 35% to 85% (with no condensation) Ambient Illuminance Incandescent lamp: 3,000 lx max. Vibration Resistance (Destruction) 10 to 55 Hz, 1.5 mm double amplitude for 2 hours each in X, Y, and Z directions Shock Resistance (Destruction) 500 m/s², 3 times each in X, Y, and Z directions Indicators Operation indicator (orange), RUN indicator (green), 7-segment indicator (white), Key lock indicator (white), Timer indicator (white), 1-point teaching mode indicator (white) Connection Method M12 4-pin connector Material (Case) Diecast zinc (nickel-plated brass) Material (Lens) Methacrylic resin (PMMA) Weight (Packed) Approx. 370 g